Manufactured using galvanised pipe work which is protected with an anti-corrosive Polyamide 11 high visibility yellow plastic coating to give good resistance to acids, bases, seawater and oils, all fittings are brass and the 250mmØ shower head and eyewash bowl are manufactured from ABS reinforced plastic. The eyewash has two high flow, aerated low pressure outlets fitted with automatic opening dust covers.
This combination safety shower and eyewash is fitted with an automatic drain system to remove residual water after use and has been designed to meet and exceed the internationally recognised standards: EN15154 parts 1 & 2, DIN12899.3 and ANSI Z358.1.
|Water inlet pressure:
||Recommended 2 bar with a maximum of 8 bar - please notify us prior to ordering if your water pressure is below 1.5 bar
|Shower flow rate:
||Regulated at 110lpm
||Automatic drain & full bore 1¼”
|Eyewash flow rate:
||Push paddle & foot treadle
||Automatic drain & full bore ½”
||76 x 25 x 20cm
Download a datasheet for CPSE
Download a technical drawing for CPSE